Ocean Modeling Discussion

ROMS/TOMS

Search for:
It is currently Sun Jul 21, 2019 8:51 am




Post new topic Reply to topic  [ 3 posts ] 

All times are UTC

Author Message
 Post subject: tracer surface flux
PostPosted: Tue Nov 13, 2018 1:12 pm 
Offline

Joined: Thu Mar 08, 2018 2:47 am
Posts: 68
Location: German Research Centre for Geosciences
I am trying to set up a very simple first test case for the implementation of the sediment tool into my ROMS model. I want a 1m layer of sand with the typical sand properties (high porosity, no cohesion etc.) evenly distributed throughout the domain with closed borders and and no suspension in the water column as an initial state. I used the sediment in file and ANA_SEDIMENT in order to set this up. I set 1 bed layer and one non-cohesive tracer in the ocean in file. The sediments then shall be eroded, suspended, transported and re-deposited according to the bottom circulation and the parameters set in the sediment in file. I thought this was quite a straightforward approach. :idea:
However, when running the case I receive an error about a missing input variable "sand_01_sflux". It confused me since I do not intent to have any surface influx of sand...
What am I missing? I'd appreciate any hints! :)


Top
 Profile  
Reply with quote  
 Post subject: Re: tracer surface flux
PostPosted: Tue Nov 13, 2018 1:41 pm 
Offline

Joined: Wed Dec 31, 2003 6:16 pm
Posts: 786
Location: USGS, USA
try using this in the project.h file

# define ANA_SMFLUX
# define ANA_BPFLUX
# define ANA_BSFLUX
# define ANA_BTFLUX
# define ANA_SPFLUX
# define ANA_SRFLUX
# define ANA_SSFLUX
# define ANA_STFLUX


Top
 Profile  
Reply with quote  
 Post subject: Re: tracer surface flux
PostPosted: Tue Nov 13, 2018 2:55 pm 
Offline

Joined: Thu Mar 08, 2018 2:47 am
Posts: 68
Location: German Research Centre for Geosciences
jcwarner wrote:
try using this in the project.h file

# define ANA_SMFLUX
# define ANA_BPFLUX
# define ANA_BSFLUX
# define ANA_BTFLUX
# define ANA_SPFLUX
# define ANA_SRFLUX
# define ANA_SSFLUX
# define ANA_STFLUX


Thanks! Switching on ANA_SPFLUX was the solution. I have an open vertical boundary so I didn't even consider switching on any of the surface flux analyticals. For the passive tracers, however, it makes perfectly sense. Thank you again! :D


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group