Ocean Modeling Discussion

ROMS/TOMS

Search for:
It is currently Sat Jun 23, 2018 12:10 pm




Post new topic Reply to topic  [ 2 posts ] 

All times are UTC

Author Message
PostPosted: Tue Nov 25, 2014 4:16 pm 
Offline
User avatar

Joined: Thu Dec 07, 2006 3:14 pm
Posts: 76
Location: USGS
I am not sure if there is any advantage to it, but in the recent version of the code sediment parameters (i.e sandmass, idBmas) are written to the his files after the wetdry mask is applied whereas in older versions it was out put as is. This change is somewhat problematic, because it makes it difficult to track the sediment mass eroded/deposited in a cell that gets wet and dry. For example if there is deposition on land during a storm surge, this information is lost under normal conditions since the land will be masked.
Zafer


Top
 Profile  
Reply with quote  
PostPosted: Fri Nov 28, 2014 2:29 pm 
Offline
User avatar

Joined: Thu Dec 07, 2006 3:14 pm
Posts: 76
Location: USGS
It seems like this issue was solved in revision 741 (ticket#648). Masks for the sediment output were switched from rmask_io back to rmask. Thanks.


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group