Boundary condition type definition at river point sources

Report or discuss software problems and other woes

Moderators: arango, robertson

Post Reply
Message
Author
User avatar
Eugen
Posts: 36
Joined: Wed Apr 06, 2016 4:36 pm
Location: University of Liege

Boundary condition type definition at river point sources

#1 Unread post by Eugen »

Dear all,

I have a problem with tidal forcing on my domain. The tidal amplitudes are too big in semi-closed bays.

How to define a boundary condition type at river point sources (like we have to do for open boundaries), to make the tides propagate?

The image below is a bias in [m]: M2 tidal amplitudes from ROMS results minus the corresponding TPXO focring.

Evgeny Ivanov

PostDoc,
MAST, University of Liege, Belgium

User avatar
kate
Posts: 4091
Joined: Wed Jul 02, 2003 5:29 pm
Location: CFOS/UAF, USA

Re: Boundary condition type definition at river point source

#2 Unread post by kate »

Tides are only forced at the open boundaries, not at rivers. You'll probably have to do something like increase the bottom drag in those bays. We have a bottom drag that's a function of depth for just such cases.

User avatar
jivica
Posts: 172
Joined: Mon May 05, 2003 2:41 pm
Location: The University of Western Australia, Perth, Australia
Contact:

Re: Boundary condition type definition at river point source

#3 Unread post by jivica »

Seems to me that tidal forcing doesn't match :?: :!: at your northern region either, this is where your BC are.
You can have amplification in the the bays, like resonance, and if you are having say 10% wrong BC than that can result with large errors elsewhere, even more in bays like that, sensitive to those periods.

I would check my BC and analysis if were you, then worry about river inlets..

Good luck!

Cheers
Ivica

Post Reply