Ocean Modeling Discussion

Hello, and thanks for the reply.

All the OBCs are stored in a single NetCDF file, and I'm only running 10-day simulations. This makes the behavior a bit strange, because there is only one time record for all the boundary conditions. Despite that, only the sea surface height (SSH), as shown in the ...

Hello everyone,

I’m running a ROMS simulation forced with the Medsea hourly boundary data (which already include tides, so I’m not adding tidal forcing separately). The model generally behaves well, but at the end of every month my sea surface height (zeta) loses its tidal variability, the signal ...

Dear all,

I am setting up a real-case simulation, and my parent model for initial and
boundary conditions is MEDSEA. According to theyr description "The hydrodynamics are supplied by the Nucleous for European Modelling of the Ocean NEMO (v4.2) and include the representation of tides ".

Do I need ...

Hello everyone

I'm runing a COAWST model, but i did some tests with only WRF .

I have some lakes which I transform into water body (I just put the whole lakemask to 0, and change these points in LU_INDEX to 16 (water body)), I checked the table parameters and looks nice.


one.JPG




After ...

Dear All,

I'm runing ROMS+SWAN+WRF model and I have problems with SWAN

I started the simulation with initial default, after 3h (5 seconds timestep 3 models) the waves still have 1mm Significant height, and a terrible resolution, it's a 600x600 grid and looks like 10x10.
Then I switched to only ...