Ocean Modeling Discussion

Hello everybody! I have a problem to restart a simulation and I hope someone could help me. I have the roms_rst.nc file and I used as initial file and changed the NRREC, but when I try to run the model has a problem, the data that the model read from the boundary file is the initial, not the data at...

Hello! I hope I can help you a little. Did you check that the oxygen was activated in the .h file? And, are you sure that the boundary configuration in the fennel.in file is correct? I think, maybe something is wrong in one of this files. A doubt, how do you kmow that the results of the boundary isn...

Hello everybody! I have a doubt, I have a NPZD_Powell version of the model and I'm trying run a Fennel version, so I change the boundary data, the forcing and grid are the same. I ran the first model in a past version of ROMS, now I'm working with the 3.9 version and I have a problem with the salin...

Hello! If the area is very shallow the problem can be the heat flux, you can try use the forcing and Qcorrection instead of Bulk Fluxes. I had a very similar problem in a shallow domain, the temperature was very high or very low.

Hi everybody! I'm running the NPZD_Powell model but the output of biological variables have negatives values. I see in the forum that the TS_MPDATA advection scheme is a solution for the problem but I can't use because I'm working in a workstation with OpenMP. Do you have any other idea about how li...

Hello! I'm working in a coastal lagoon model with a river, but I have a problem. In the surface the salinity is normal but in the three last levels in the point of origin of the river the salinity is too high. I tried with diferents salinitys and transports (negative and positive) and the problem is...